#Amberlight software install
#Amberlight software update
#Amberlight software for android
#Amberlight software series

Sleep Timer - the TV will turn off after a set amount of time.

A solid Orange/Amber light means that a timer has been set and is active on the television.

For Projection TVs and Projectors, make sure that the cover/door for the lamp is closed and secure.

If you have one of these TVs, check to make sure the cable between the media box and the display is securely connected.

Some Sony TVs have a media box (tuner) and separate display.

Other things to check for some specific products.

#Amberlight software update

Older CRT TV's and TV's that cannot be connected to the Internet do not have an option to check for a software update or may not capable of being updated.

If you only have this option, make sure it is set to On.

For a limited number of Internet-capable models, the only option is to turn on Automatic Software Updates and allow the TV to update on its own.

#Amberlight software install

Steps to install will be included if an update is available. In addition, you can check to see if a software (firmware) update is available for your television on our support site. The Software Update option is usually found under the Product Support or Contact Sony menu. If your TV is connected to the Internet, press the Home or Menu button on the remote to get into the setting menus.

Update the TV software to the latest version.

If it does not blink, the issue may be in the connected devices. With all devices disconnected, turn on the TV again and check whether the LED blinks. Turn off the TV and disconnect all connected devices.

Turn off the TV and unplug all devices connected to the TV.

Make sure there is room for air to circulate around the cabinet of the TV.

Clean any vents/slots in the TV cabinet.

You may need to wait several minutes before these will turn back on.

Projection TVs and projectors need to cool down before they will turn on again.If the issue is resolved, the problem is with the power strip or surge protector and not the television. If the TV is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet.For a Projection TV or Projector, leave it off for 3 minutes. If the TV will not respond to the remote or the power button, or if that does not fix the issue, unplug the TV. This is a model-specific issue that may be resolved by following these steps (please check the answer to be sure your model is included). NOTE: 8 Times Blink - For certain models, a special reset procedure is needed if the Red LED on the front of the TV is blinking 8 times and then repeats.

If the procedure does not solve the issue and the Red LED is still blinking, check how many times it blinks and then contact support.

If a Red LED is blinking, try the troubleshooting procedure below.

However, the number of blinking times is mostly 2 to 8.

The meaning of the blink codes differs between TV models.

Most Red LED blink conditions require service.

If a Red LED is blinking and the TV is not working properly it means that the TV has detected an issue or problem.

There may be one or more lights and on newer sets, one light may change color to indicate different conditions or to show that certain features are enabled.Ĭheck the table below for common meanings of the indicator lights and troubleshooting steps to help resolve any issues. LED Indicator lights are normally found on the lower front of the TV. The Illumination LED or bottom of the screen lights up or blinking in different colors.

#Amberlight software series

KDLxxW7xxB Series, KDLxxW8xxB Series, KDLxxW9xxB Series, KDxxX8xxxB Series, KDxxX9xxxB Series, W70xC Series, W78xC Series, X8xxB Series, X9xxB Series

#Amberlight software for android

IMPORTANT: For Android TV™ or the following series, refer to the article below.